Fire Hydrant Valves
Test pressure 2.7 MPa. Installation and commissioning to AS2419.1. Design and manufactured to AS2419.2 contamination of water : complies to AS3855. Pressure loss : not exceeding 25KPa @ 25L/s.
A hydrant installation is made up of a tee, riser pipe, tapping block (insome cases), hydrant valve, and cover. The size of hydrant valve,block, and riser often installed in the past was 65mm (2 1/2”) nominaldiameter which has now been found generally inadequate for modernfire fighting.
In line with local and international installation methods our main core products are the roll grooved range of Pipe, Valves, Fittings and Couplings, this system is available from 50mm to 300mm and beyond and is used on almost every fire service being installed around the country today.
